تكفون ابغى حل للسؤال هذا

[reemy2012]

write a Java program that will convert an input metric to a corresponding value in the International System of Units. Input metric will be in Yards, Inches, Miles, and Pounds. The converted metric should be converted as follows:
Table 1:

Input metric output metric
Yards meters
Inches centimeters
Miles kilometers
Pounds kilogram

The program should display a Menu for the user to choose from the above metric. The menu is shown in the figure below.

Welcome to Multi conversion System
Press c for Inches to Centimeters
Press m for Yards to Meters
Press k for Miles to Kilometers
Press g for Pounds to Kilograms
Press e for exit

The user has to enter c, m, k, or g. Next, the user will enter a value for the input metric which the program will convert to the specified unit from table 1. The user has to enter e to exit from the program. The output of the program should be the converted metric value. In addition, consider the following scenarios in the output:
1. If the user inputs a character that is not recognized (NOT c, m, k, g or e), then the program prints “Wrong Selection!”.
2. If the user inputs a value less than zero for a metric, the program will display a message that states “Cannot convert a negative value!”
3. After displaying the converted metric value (if input value is not negative), the program should also display the range of the converted value according to the following rules:
a. If converted value is less than 20, print “Less than 20.”
b. If converted value is less than 50, print “Less than 50.”
c. If converted value is equal 50, print “Equal 50”.
d. If converted value is greater than 50, print “Greater than 50.”

Hint 1: To read a character using a Scanner input, use the following statement:
char c = input.nextLine().charAt(0);
Hint 2: To convert a metric use the following formulas:
Centimeters = 2.54 * inches
Meters = 0.9144 * Yards
Kilometers = 1.60934 * Miles
Kilograms = 0.453592 * Pounds

Hint 3: If the user enter e to exit from program, use the following statement to exit:
System.exit(0);.

[شروق آلحربي]

وانا بعد حايسه فيه :(

لو احد يعطينا فكرة الحل فقط مو شرط البرنامج كامل :)

[~manoo~]

و انا بعد يااليت احد يساعدنا في حله :(

[The love roots]

هادا السؤال فين؟؟